Erico IP7451A SBC105R Mold Assembly with Quick Grip Exte User Manual download pdf

Figure 3

Figure 2

Mold is not supplied with clamp, must be ordered separately

See reverse for attachment of assembly to rail

Figure 1

Nose of mold

Prior to making a connection, read and follow the full instruction sheets IPP, IPX,

IPRLBR and special instructions below.

Remove item 1 (hex bolt) and item 2 (hex nut) from clamp assembly (As

shown in Figure 1).

Place mold between mounting frame, with nose of mold facing inward (As

shown in Figure 2).

Insert hex bolt through one side of frame, then through mold and opposite side

of frame (As shown in Figure 3).

Secure assembly with item 2 (hex nut) to item 1 (hex nut). Tighten nut until nut

is flush with frame.

Do not over tighten

and cause frame to bend.

Center mold in frame by adjusting item 3 (thumb screws) into counterbored

holes provided in side of mold.

Do not tighten.

Mold should "float" slightly

within the assembly for seal against rail during usage.

Tighten item 4 (hex nuts) on item 3 (thumb screws) to mold frame.

TECHNICAL SUPPORT:

www.erico.com

IP7451A_B

INSTRUCTION SHEET

1 OF 2

ERICO International Corporation

SBC105R Mold

Assembly with

Quick Grip

Extension Clamp

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com

and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

All instructions must be

completely

followed to ensure proper and safe installation and performance.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

1 2

Summary of Contents

Page 1 - Extension Clamp

341Figure 3Figure 2Mold is not supplied with clamp, must be ordered separatelySee reverse for attachment of assembly to railFigure 12Nose of moldPrior

Page 2 - Grip Extension Clamp

28" [711mm] Max Head Clearance 25.5" [648mm] Max Clamp Web to Web] NeutralAxisAdjustable Swivel PadMoldHeight Adjustment ScrewC105R Clamp

Comments to this Manuals

No comments

Erico IP7451A SBC105R Mold Assembly with Quick Grip Exte User Manual

Browse online or download User Manual for Accessories for electrical Erico IP7451A SBC105R Mold Assembly with Quick Grip Exte. ERICO IP7451A SBC105R Mold Assembly with Quick Grip Extension Clamp User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for electrical Erico IP7451A SBC105R Mold Assembly with Quick Grip Exte