Erico Standard Bar Threader User Manual

Standard Bar Threader Instruction Manual

www.erico.com10131314141414Before replacing the holders make sure the cavity in the head and the holders are clear and free of chips. Wipe all flat su

www.erico.com1116 16After the holders have been installed in the cutting square, check that the numbers on the face of the holders match the correspon

www.erico.com121717161618Turn on the machine and move the body of the machine back and forth to make sure the holders are opening and closing properly

www.erico.com13 Change Control BlockTo change the control block, remove the face plate. Three bolts hold it in place.Remove the chaser holders from t

www.erico.com14 Change Control BlockWipe the holders clean of any chips and contaminants. The number 1 holder, with the slot in it to accept the cont

www.erico.com15 Threading OperationPrior to positioning the rebar in the machine, be sure that the machine carriage is all the way back to the right.

www.erico.com1611 Threading OperationMake sure oil is flowing into the head of the bar threader. If it is, then with the right hand handle move the b

www.erico.com17The thread profile should be checked with a brand new chaser. To check the length of the thread, slide the bar end gauge over the bar an

www.erico.com18Machine chips are caught in the screened drawer above the oil reservoir. The drawer should be emptied as required during the machining

www.erico.com191. If the Standard Bar Threader will not start, check the following: a. The machine is plugged in and the power is on. b. Machine

www.erico.com2WARNING1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. I

Copyright ©2010, 2011 ERICO International Corporation. All rights reserved. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered

www.erico.com34321The Standard Bar Threader will be shipped in a crate like the one shown above.To open, remove the three bolts on either side of the

www.erico.com4The bar threader requires 220-240 volt, 3 phase power. A four-pronged locking plug (as shown) is standard.After connecting the power be

www.erico.com5To change centers to a different bar size or to go with a set that fits the bar better, push in the release ring and pull out the existin

www.erico.com6Prior to threading, the oil must be added. Pour the oil into the chip funnel and it will flow into the oil reservoir. Only part #ELOIL oi

www.erico.com7To change the control key, remove the support rod screw, compression spring, and the support rod from the head.Loosen and remove the bac

www.erico.com8Remove the face plate bolts. Three bolts hold it in place. Change Chasers and HoldersRemove the holders from the head of the bar thread

www.erico.com9Before installing the chasers make sure the woodruff key (ELMP223) is tight. Press on both ends of the woodruff key with an allen wrench